Fixing A Metal Plate To Candlesticks

Fix the base in the turn with the stick to cross in octagon, stick it to the base by using a piece of finger. While this dries is a good time to manufacture a plate before special holding the base in the turn. The tail stock holds the end of the stick. My plate before made on order started by an aluminum 3” dish (6). I screwed a piece of 1” - the thick hard maple which had been cut” the circle to 3 with him and to the bottom turned him with just more than 3” of diameter beside the 3 below metal plate and right” on the other end. To drill one 3/16” hole in the center while the front plate is still assembled on the headstock. To cut a piece of 3/16” - the steel stem of diameter approximately to 1 “.
Throw in the pressure and the file of drill or to rectify the end at a very pointed point while the stem turns. To stick this stem in the hole in the plate before so that only 1/8” to 5/32” of the point is proud surface. The metal plate I employed has two sets of holes of support. I was accustomed to the external holes to screw the dish with the face out of wooden. I drilled holes by the face out of wooden by the interior whole of holes of support. Then I ran 1 “the screws length of head of pan by the latter hole so that the points of the screws exceeded 3/32” or less beyond the surface of the face out of wooden (7). If your screws are too long, to use the discs to adjust them so that very little point shows.
The needle stem, which should further exceed that the screws, and these four screws act a center of tooth just like. It takes a little crushing with a mallet to assemble the white to the front plate. But you do not want to hammer directly on of metal plate; you’ll want to employ a piece of fall to protect it.