It’s actually not that difficult to refinish a wood floor yourself. You’ll need a drum or belt sander and multiple grades of sandpaper to go with it. You can rent the sander from your local hardware store, and most likely, they can suggest the grades of sandpaper you will require. Standard grade is about 20, but you may need up to 100 to get gouges and real rough spots out. Be sure to also obtain dust masks for you face, or a respirator, as you will be generating lots of wood and finish dust. You might want to isolate the room you are doing away from other rooms in your house with plastic sheeting. Ventilation in the work area is a must. You have removed all the furniture and wall hangings like paintings from the room, right?
Before you start sanding, check the floor for any nails, staples or tacks that may be protruding above the surface. These things can tear up your sandpaper quickly and even ruin the sander belt or disk if they are not removed. The key to good sanding is to keep the sander moving and go with the wood grain, not across it. If you stop while the sander is running, you may produce a gouge or burn in that area. You should also consider wearing ear protection while doing this job. These sanders are loud. Don’t wear very loose fitting clothing that may get caught by the sander. Gloves are very helpful as well.
After your finished sanding, clean the area extremely well by first sweeping up with a broom, then a shop vac and finally a damp mop. Let the floor dry and settle overnight. Damp mop again the next morning and allow to dry a few more hours.
What type of finish did you decide on? Three coats are usually required, the base coat, the color (if used) and the top coat for durability. Pick from an oil based or polyurethane, water based finish. If you select an oil based finish, you need to decide if you want a satin, semi gloss or gloss finish. A satin oil based finish, just like a semi gloss or flat wall paint, hide blemishes better. Water based products dry much more quickly and resist any yellowing that might occur. PLEASE pick a corner and try your stain selection BEFORE you finish the entire floor. I can’t stress this enough. If you are satisfied with the results, you can apply the stain to the rest of the floor using a brush or roller and evening it out with a clean soft rag. Be sure to let the coats dry according to the manufacturer’s directions. Remember, again, ventilation is REQUIRED for you and your room.
Refinishing is a means to increase durability of your floor and enhance its appearance, and is a three-stage process of sanding, staining, and finishing that CAN be done yourself.
More Post
New Medicines Available To Treat Rare Diseases
Music now we learn also on-line
Give A Heart Necklace This Holiday
Cure your Baldness & Alopecia the Natural Way (Chinese Herbs)
Teach Courses Online
Facts About Spirulina- Worlds Most Powerful Food
School Fundraiser Niche - Valentines Day
Hair Loss: Cosmetic Solutions For Good Cover Up
Dating Blindly
Sun Tanning Protects The Skin
Thay Call It "Dog Breath" For A Reason
Using Magnets To Fight The Pain
A Note From Saint Valentine - A First Person Tale Of This Wonderful Day
Spitting Up – And Other Joys Of Motherhood
Las Vegas: How to Ensure Your Vacation is Full of Adventure and Kicks
Is Self-Esteem Contrary to Christianity
What Educational Toys Do Kids Actually Enjoy Playing With?
MLM Success | Relationships in Two Minutes Flat
Are vent free gas fireplaces safe?
Domestic Violence Dr Jekyll or Mr Hyde