To throw 1" a little right in your router and to place it for a cut of 3/32" - deeply. To light then. To judge above on the tight and regulated candlestick it to the bottom with the medium (26). Without turning the candlestick, to make the turns in the direction of the needles of a watch inside the gauge until the edge of the base rubs on the gauge, then to make with a couple more passages to ensure any material than you want to remove was removed. All that should remain is a very small hole where the needle stem penetrated wood. And that’s no ugly of the whole. If all were well, you have a bottom dug-outside with approximately 1" "Florida" on surface between the cavity and the cone which will rest some well on that.
Now you can put completion on naked wood. Only one stage remains before obtaining with the handle: drilling of a hole for the candle. The size of the hole will be determined by the kind of candle which you have the intention to employ. My choice was of the 8” the federal candle, which is right. I threw one 13/16" little in the pressure drill and drilled with a depth of approximately 28".